Your basement floor carries the weight of everything above it and must stay dry for decades. Regina Concrete installs basement slabs with sealed vapor barriers, proper underlayment, and finishes flat enough for tile, plank, carpet, or a polished concrete surface. Whether you're building new or replacing a failed slab, we start with a free site visit and written quote.
Why Basement Slab Installation Requires the Right Base
A basement floor is only as good as what sits beneath it. Pour concrete directly on soil without a vapor barrier and groundwater will wick up through the slab for the life of the building, turning any finish above into a maintenance nightmare. Slope the slab wrong and water pools in corners. Skip the reinforcement and cracks follow settlement.
We build basement slabs the way they need to be built. The subgrade gets compacted and leveled to plan. A sealed vapor barrier goes down with overlapped seams taped at every joint. Rebar or mesh sits at the right height. The concrete gets screeded flat, finished smooth or polished depending on what goes on top, and saw-cut on schedule to control cracking.
We check the basement floor elevation, soil conditions, any existing drainage issues, and confirm where plumbing or mechanical stubs need protection before concrete work begins.
Compact and prepare the base
The subgrade is compacted to density, gravel is added where needed, and the surface is brought to the correct elevation so the slab sits at plan height.
Install vapor barrier and reinforcement
A sealed vapor barrier is laid with overlapped seams, rigid foam underlayment is added if specified, and rebar or wire mesh is positioned at the correct height for slab thickness.
Pour, screed, and finish the slab
Concrete is placed, screeded to a flat plane, bull-floated smooth, and finished to match the final surface (smooth for tile, polished if the slab is the floor itself).
Saw-cut joints and cure
Control joints are saw-cut on the proper schedule, the slab is protected during cure, and you receive it ready for trades to begin finishing work above.
When the old slab has to go
Replacing a Failed Basement Floor the Right Way
A cracked, wet, or sloped basement floor usually signals a deeper problem. Missing vapor barrier, poor drainage, settlement, or a subgrade that was never compacted properly. Pouring a new slab on top of a failed one without fixing the cause means the new floor will fail the same way.
We diagnose first. Sometimes a waterproofing system or crack injection solves the issue. Often, a full tear-out and replacement is the honest answer. The quote will tell you which path makes sense for your basement.
New builds, replacement slabs, vapor barriers and finish-ready floors in Regina basements.
Yes, in Regina basements where the ground is consistently damp, a sealed vapor barrier under the slab is essential. Without it, moisture migrates up through the concrete for decades and ruins finishes on top, no matter how good the slab itself is.
Yes, polished basement floors are a real option here. We adjust the finishing pass, then grind, hone and polish the slab to the gloss level chosen, and the basement floor itself becomes the durable, low-maintenance finish.
Yes. Cracked or wet slabs almost always have an underlying cause, missing barrier, bad drainage, settlement. We diagnose it, fix that, then pour a new slab on the corrected base so the new floor does not inherit the old problem.
Most residential basement slabs are several inches thick over the prepared subgrade, reinforced with mesh or rebar. Exact thickness depends on the slab's use and the engineer's spec; the quote ties to your build.
You can usually walk on it within a day or two, but moisture testing should drive when finishes go on top. We hand back the slab with cure-time guidance so the tile, plank or carpet above does not get applied too early.
Homeowner reviews
What Regina Homeowners Say About Their Basement Floors
They flagged the missing vapor barrier under our old slab before quoting. Re-poured properly, sealed seams. Two springs in, the new floor is dry. Total game-changer for the basement.
Z. A.
Regina
★★★★★
Polished basement floor and it looks incredible. They adjusted the finishing pass for the polish, then ground and honed it themselves. One contractor, slab to shine.
Y. X.
Regina
★★★★★
New build basement floor poured perfectly flat. The tile guys came in after and said it was the easiest install they had done all year. Their flatness call paid off.
Y. N.
Emerald Park
★★★★★
Tore out a slab that had been pouring wet for years. They found the source, fixed it, then poured a new one. Honest sequence, honest quote. Basement is finally usable.
W. D.
White City
From the blog
Concrete Guides & Articles
Practical reading on planning, finishes and caring for concrete in Regina.
Tell us whether this is a new build, a replacement slab, or a polished-floor project, and we will quote the basement floor in writing after a free on-site measure.
