When concrete leaks or fails, Sika is the chemistry we reach for. We install Sika elastomeric membranes, polyurethane injection systems, structural repair mortars and floor topcoats to the full manufacturer specification, primer through topcoat, in the exact sequence and cure schedule the product requires. Every job gets a free written estimate.
Where Sika Repair and Waterproofing Earn Their Keep
Water finds its way into concrete through cracks, pores and joints. Sika waterproofing membranes (Sikalastic, Sikagard) are elastomeric, meaning they flex as the concrete moves with temperature and load, instead of cracking and peeling like rigid coatings do.
We evaluate whether the issue is preventive waterproofing, an active leak, structural damage or a finished floor, then match the right Sika product line and chemistry to the substrate and environment.
Prepare the surface to spec
Concrete is cleaned, profiled and tested for moisture content to meet the Sika system requirements. Cracks are routed and cleaned if injection is the solution.
Install primer, body and topcoat
Each layer of the Sika system goes down in the published order, at the specified thickness and temperature, with the correct cure time between coats before the next layer begins.
Document and hand over warranty
The install is photographed and documented, cure times are observed, and you receive the product data sheets and warranty information for future reference and compatibility.
Below-grade protection
Sika Waterproofing and Injection Below Grade
Most of our Sika work happens on foundation walls and basement slabs, where water pressure and freeze-thaw cycles test every coating. Sika elastomeric waterproofing flexes with concrete movement instead of cracking, which is why it holds up where rigid products fail.
For existing leaks, Sika crack injection seals from the inside without digging up the exterior. Sika repair mortars restore structural integrity to damaged concrete. The combination is why a Sika install stays dry through multiple seasons, rather than becoming a repeat project each spring.
Which Sika line for which job, injection, waterproofing and warranty in Regina.
Often, yes. Sika crack injection with SikaFix HH polyurethane seals active cracks from inside the wall and stops the leak, without needing to excavate the outside of the foundation in most cases.
Sika waterproofing is a system applied to a whole wall or slab to keep water out. Crack injection is a targeted repair that seals a specific crack already letting water through.
Yes, the right one can. Sika MonoTop repair mortars rebuild spalled and structural concrete to original profile and strength, with the chemistry chosen to suit whether the repair is cosmetic or load-bearing.
Because elastomeric chemistry actually flexes with concrete movement. A rigid coating cracks where the substrate moves, and the leak comes back. Sika systems were developed to flex and seal, which is why they hold up below grade.
Yes. We install Sika products as a system, primer, body and topcoat in the published sequence and chemistry. That is what keeps the manufacturer warranty intact and what makes the install actually perform.
Sika crack injection stopped a leak we had chased with caulking for years. They sealed it from inside and the basement has been dry through two springs.
M. E.
Homeowner
★★★★★
Full Sika waterproofing on a new foundation. Elastomeric so it can flex with the concrete and not crack off the way the old rigid coating did.
A. D.
Builder
★★★★★
SikaTop repair on a worn loading-dock area. Profile is exact, took our forklift traffic, and they handed over the data sheets for our records.
J. E.
Commercial property manager
★★★★★
They install Sika as a full system, not just a coat of the product they have on the truck. That difference shows up in how long the install holds.
L. G.
General contractor
From the blog
Concrete Guides & Articles
Practical reading on planning, finishes and caring for concrete in Regina.
A leaking foundation, an active crack, structural damage or a concrete floor that needs finishing, tell us what is happening and we will spec the right Sika system and send a written, itemized quote.
